VZClip, an innovative hidden clip and fastener system from VERSATEX Building Products, speeds up and simplifies the installation of two widely used VERSATEX PVC ¾-inch trim profiles. Not only that: Test-site data shows that VZClip keeps VERSATEX Canvas Series and reversable WP4/Nickel Gap trimboards firmly in place even at wind loads in excess of 125 mph.
Traditionally, avoiding running fasteners through the face of a trimboard was designed for lasting good looks. The traditional alternative—securing T&G with a nail through the tongue or groove—is time-consuming and doesn’t achieve the holding power we’re looking for in a coastal environment.
The VZClip sidesteps both issues. It’s a one-piece, hidden clip and fastener system that’s compatible with either of these VERSATEX profiles. It reduces installation time and assures that the board is properly secured to the framing member. It all adds up to more confidence for the installer.
In negative windload tests by an independent, accredited, third-party testing agency, VZClips exceeded the equivalent windload of a Category 3 hurricane.
The new clip and fastening system saves time and simplifies field installation, while preserving the smooth curb appeal of unmarred PVC or film-laminated color surfaces.
VERSATEX recommends installing VZClips every 16 inches on center, using #8 15/8-inch galvanized or stainless-steel screws. A package of VZClips (screws not included) will cover about 180 square feet, or approximately 21 18-foot boards. Contractors and builders can buy standard, galvanized VZClips now through VERSATEX dealers. A stainless-steel version for coastal applications will be available later this year.